Hardware Overview
LEDs
The XP-8600 Switching Fabric module uses the following LEDs.
LED
Offline
Online
Active
Line Cards
The following table lists the line cards available for the XP. The line cards are equipped
with 4 MB, 16 MB, or 32MB of RAM.
Enterasys
Part Number
AA Cards
G8M-HTXA2-08
G8M-HFXA1-08
G8M-GLHA8-01
G8M-SECAC-04
G8M-SCEAC-04
G8M-HSIAC-02
18
Description
When lit, this amber LED indicates that the module is offline
(powered off) and is ready for hot swap.
The Offline LED also is lit briefly during a reboot or reset of the
XP and goes out as soon as the control module discovers and
properly initializes the switching fabric module.
When lit, this green LED indicates that the module is online
and is ready to receive, process, and send packets if configured
to do so.
When lit, this LED indicates that the switching fabric module
is actively receiving, processing, and sending packets.
All pre
WFQ
3.0 Firmware:
3.0
NAT, LSNAT, QoS,
Firmware
Rate Limiting, TOS
Release
Rewrite, Per
Protocol VLANs,
Established Bit
ACL
3.1 Firmware:
L4 Bridging, Mult
IPX Encap
X
X
X
X
X
X
X
X
X
X
X
Enterasys Xpedition 8000/8600 Getting Started Guide
Routing
Table on
line card,
WRED,
Per Port
Rate
Limiting
X
X
X
X
X
X
Jumbo
Frame