Table of Contents
Advertisement
Installing the Hardware
2.
Slide the line card all the way into the slot, firmly but gently pressing the line card
fully in place to ensure that the pins on the back of the line card are completely seated
in the backplane.
Note:
3.
Use the #2 Phillips screwdriver to tighten the captive screws on each side of the line
card to secure the line card to the chassis.
4.
Repeat the above steps for the remaining cards.
5.
When you are ready to attach the segment cables, use the procedures in Attaching the
Segment Cables
Installing the ATM PHY Cards
Each ATM line card has two slots available for PHY cards. One ATM PHY card can be
installed into each available slot. You will need a #2 Phillips screwdriver to perform this
procedure.
Figure 35
figure describes how to do this.
64
Make sure the circuit card (and not the metal plate) is between the card
guides, as shown in
tracks.
on page
68.
shows an example of how to install a PHY card. The procedure following the
Figure 31 on page
59. Check both the upper and lower
Enterasys Xpedition 8000/8600 Getting Started Guide
Advertisement
Table of Contents
