Table of Contents
Advertisement
Hardware Overview
External Controls
The control module has the following external controls. Where appropriate, this guide
describes how to use the controls.
•
Male DB-9 Data Communications Equipment (DCE) port for serial connection from a
management terminal. Use this port to establish a direct CLI connection to the XP. The
default baud rate is 9600.
•
10/100Base-TX Data Terminal Equipment (DTE) port for network ("in-band")
connection from a management terminal. The port is configured as a Media Data
Interface (MDI). Use this port to establish a management connection to the XP over a
local or bridged Ethernet segment.
•
Reset switch (RST). Use this switch to reboot the XP's CPU.
•
PC flash memory slots. These slots let you install system image software upgrades as
well as older system image software versions.
You can install a PC card in either slot but you cannot use two PC cards at the
Note:
same time.
AC Power Supply
The power supply delivers 3.3, 5, and 12 DC volts to the XP's control module(s), fan
modules, and other components. A single power supply provides enough current to
operate a fully configured chassis. The power supply has its own internal cooling fan. The
vent on the front of the power supply is the inlet vent for the cooling fan.
Figure 4
shows the front view of an XP-8000 AC power supply.
14
PWR
G80-PAC
100-125~5A
200-240~3A
50-60 Hz
Figure 4. Front view of an XP-8000 AC power supply
Enterasys Xpedition 8000/8600 Getting Started Guide
Advertisement
Table of Contents
