Chapter 2: Installation; Required Tools - Enterasys SSA-T1068-0652 Hardware Installation Manual

Follow the order of the sections listed below for correct installation:
For information about...

Required Tools

Unpacking the SSA
Mounting the SSA
Unpacking the Power Supplies
Installing the Power Supplies
Powering Up the SSA
Connecting to the Network
Connecting to the COM Port for Local Management
Completing the Installation
Read the Release Notes specific to the firmware image running in the chassis to check for any
exceptions to the supported features and operation documented in this guide.
Required Tools
• ESD wrist strap (included with the SSA)
• Phillips screwdriver
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und qualifiziertes
Personal vorgenommen werden.
Important Notice
Enterasys S-Series Stand Alone (SSA) Hardware Installation Guide 2-1
2
Installation
Refer to page...
2-1
2-2
2-3
2-12
2-13
2-14
2-16
2-18
2-20