Flat Surface Installation; Unpacking The Power Supplies; Installing The Power Supplies; Contents Of 7100G-Series Power Supply Carton - Enterasys 7100G Series Hardware Installation Manual

Unpacking the Power Supplies

You can now install the 7100G-Series power supplies. See
page 2-12.

Flat Surface Installation

For flat surface installation, optionally attach the adhesive rubber feet to the bottom of the
7100G-Series switch.
To attach the rubber feet to the bottom of the 7100G-Series switch:
1. Place the 7100G-Series switch upside down on a sturdy, flat surface.
2. Remove the adhesive backing from the four rubber feet.
3. Adhere the rubber feet to the round, recessed areas on the bottom of the 7100G-Series switch.
You can now install the 7100G-Series power supplies. See
page 2-12.

Unpacking the Power Supplies

The power supply modules are shipped in boxes separate from the 7100G-Series switch. To
unpack a power supply:
1. Remove the power supply from the shipping box and slide the two foam end caps off the unit.
Save the shipping box and materials in the event the unit must be reshipped.
2. Verify the contents of the box using
3. Remove the power supply from its protective plastic bag.
4. Examine the power supply carefully, checking for damage.
If there are any signs of damage, DO NOT install the power supply; instead, contact Enterasys
Networks. Refer to
Table 2-4 Contents of 7100G-Series Power Supply Carton
Item
Power supply (71A-PS-A, 71A-PS-B, 71A-POE-A, or 71A-POE-B)
For USA shipments: NEMA Power Cord 5-15, C13
Type of power cord is dependent on country of installation.
IMPORTANT AIR FLOW NOTICE

Installing the Power Supplies

If you are installing only one power supply, you must put the power supply in the left power
supply bay (labeled PS1). The 7100G-Series switch ships without a coverplate for the PS1 bay.
To install the power supplies in the 7100G-Series switch:
1. Use appropriate antistatic protection when handling power supplies.
2. Perform a visual verification of the power supply air flow direction, verifying that the power
supply air flow direction agrees with the installed fan module air flow direction. For details,
see
2-12 Installation
"Getting Help"
"Power Supply Air Flow and Switch Fan Module Air
"Installing the Power
"Installing the Power
Table 2-4.
on page xvii for details.
Flow" on page 2-4.
Supplies" on
Supplies" on
Quantity
1
1
1