Basic Faxing; To Fax Using The Automatic Document Feeder - Konica Minolta Fax Kit (FX-3) User Manual

3
3.3

Basic Faxing

To fax using the Automatic Document Feeder

1
Press the [Fax] key.
The machine enters Fax mode,
and the fax screen appears.
2
Load the document to be faxed
into the Automatic Document
Feeder.
❍ Adjust the Document Guide
Plates to fit the size of the
document.
❍ Load the document face up.
Tip
If a double-sided document is loaded into the Duplexing Document Feeder
(Option for the Di2011 only), press the [Original] key until the "Duplex Orig."
function is selected.
3
If necessary, change the "Resolution" setting (p. 3-11).
4
Using the 10-Key Pad, enter the
fax number of the recipient.
❍ The fax number of a previously
programmed recipient can also
be specified. Refer to "Dialing"
on page 3-2.
5
Press the [Start] key to begin scanning and sending the fax.
❍ To stop the transmission, press the [Stop] key, and then press the [Yes] key
in the next screen that appears.
Once transmission is finished, a beep is sounded.
If the fax could not be sent, the transmission result report is printed (p. 6-48).
3-12
3.3 Basic Faxing
Fax Kit (FX-3)