Main Error Messages And Their Remedies - Konica Minolta Fax Kit (FX-3) User Manual

7
7.1

Main Error Messages and Their Remedies

Message
LINE PROBLEM
(Flashing alternately)
CHECK LINE
∗ ∗
COMM.ERROR
∗ ∗
REDIAL ALL FAILED
∗
MEM.FULL/TX CANCEL
∗
MEM.FULL/RX CANCEL
HANG UP THE PHONE
×
TEXT 1.00 1
ä[A]ü #XXX: Fax Err
×
TEXT 1.00 1
ä[A]ü #XXX: Comm.Err
∗ ∗
PLEASE WAIT!
ADMINISTERED BY PC
7-2
7.1 Main Error Messages and Their Remedies
Cause
• The telephone dialing system
or telephone wiring system are
not set correctly.
• The telephone cable is not
attached correctly.
• Communication is not possible
(####) because of some problem in
the machine.
• Communication is not possible
because of a problem with the
recipient/caller's fax machine.
All redial attempts failed because
either the recipient's line is busy
or there was no answer.
∗
While sending a fax, the size of
the data for the scanned image
has exceeded the capacity of the
memory.
∗
While receiving a fax, the size of
the data for the scanned image
has exceeded the capacity of the
memory.
The receiver of the connected
telephone is lifted.
A fax error occurred while an
operation was being performed in
Copy mode.
A fax transmission error occurred
while an operation was being
performed in Copy mode.
This machine is accessing LSD,
RSD or the Admin. Mode of
PageScope Light.
Remedy
• Check the telephone dialing
system or telephone wiring
system and use the
appropriate Utility mode
function to make the correct
settings.
• Correctly connect the
telephone cable.
Check the transmission results.
Check the condition of the
recipient's line, and then try
sending the fax again.
• Retrieve all received faxes
stored in the memory.
• Send the fax by direct
transmission.
Retrieve all received faxes stored
in the memory.
Replace the receiver of the
connected telephone on the
hook.
Press the [Fax] key to check the
error condition, and take
appropriate measures.
Press the [Fax] key to check the
error condition, and take
appropriate measures.
• Log off from PageScope Light
or LSD or quit communications
with RSD.
• If no operation is performed for
600 seconds, the main screen
appears.
Fax Kit (FX-3)