Document Glass - Fuji Xerox ApeosPort-IV C7780 User Manual

1
Remove any paper clips and staples before
loading a document.
2
Adjust the document guides to match the size of
the document loaded.
Note • When loading a large size document such as
3
Load the document face up (when the document
is 2-sided, load the front side up) in the center of
the document feeder.
Note • The Confirmation indicator lights up when the
• When the document is loaded in the document

Document Glass

The document glass supports a single sheet, a book, or other similar documents with
sizes from 15 x 15 mm to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard
size documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard
document size, refer to "Original Size (Specifying the Scan Size for the Document)" (P.111).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the
System Administration mode. For information on the paper size settings, refer to "5 Tools" > "Common
Service Settings" > "Other Settings" > "Paper Size Settings" in the Administrator Guide.
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
1
Open the document cover.
Important • Ensure that the touch screen is active,
A3, lift up the document feeder tray, and open
the document stopper rightward.
document is loaded correctly.
feeder, the document feeder tray lifts up. You
can set the timing of the lift. For more
information, refer to "5 Tools" > "Common
Service Settings" > "Other Settings" >
"Document Feeder Tray Elevation" in the
Administrator Guide.
and then load a document. Otherwise, the
machine may not properly detect the
document size.
Copying Procedure
Document stopper
Confirmation indicator
71
3