Operational Safety - Fuji Xerox ApeosPort-IV C7780 User Manual

1 Before Using the Machine
1

Operational Safety

24
Always lock the wheels of this product after installation. Otherwise, it may fall
over or slide and cause injuries.
To bundle wires and cables, always use the cable ties and spiral tubes that Fuji
Xerox supplies. Otherwise, it may cause some defects.
To keep this product in a good performance and condition, always use it in the
following environment:
Temperature: 10 32 °C
-
Humidity: 15 85%
-
When the product is left in a chilly room and the room is rapidly warmed up by
heater, dew condensation may form inside the product and cause a partial
deletion on printing.
The operator's product maintenance procedures are described in the customer
documentation supplied with this product. Do not carry out any other
maintenance procedures not described in the documentation.
This product features safety design not to allow operators access to hazard
areas. The hazard areas are isolated from operators by covers or protectors
which require a tool to remove. To prevent electric shock and injuries, never
remove those covers and protectors.
To avoid the risk of electric shock and a fire accident, switch off the power and
then the main power inside the body front cover. Unplug the product promptly
in the following conditions, then contact your local Fuji Xerox representative.
The product emits smoke or its surface is unusually hot.
The product emits unusual noise or odor.
The power cord is cracked or worn down.
A circuit breaker, fuse or any other safety device is activated.
Any liquid is spilled into the product.
The product is soaked in water.
Any part of the product is damaged.