Specifying A Destination Using A One Touch Button - Fuji Xerox ApeosPort-IV C7780 User Manual

When using wildcards for the last two digits
How to Enter Wildcard
When you specify address numbers, confirm that the corresponding fax numbers are correctly registered
on the machine. For information on how to register address numbers, refer to "5 Tools" > "Setup" >
"Add Address Book Entry" in the Administrator Guide.
Note • The maximum number of recipients that you can specify at one time is as follows:
• An address number is always displayed in four digits. If [Auto Validation of Speed Dial Entry]
• You can use wildcards only for the last digit or last two digits of address numbers. The
1
Press the <Speed Dial> button, and enter a
4-digit address number. Repeat this step for
each additional recipient.

Specifying a Destination Using a One Touch Button

You can use the one touch buttons to specify recipients.
One touch buttons correspond to the address numbers from 0001 to 0070, or 0001 to
0060.
For example, when the number you want to dial is registered to the address number
0001, press one touch button <1>.
For information on how to register address numbers, refer to "5 Tools" > "Setup" > "Add Address Book
Entry" in the Administrator Guide.
Note • There are two ways in which address numbers and stored programs are assigned to the one
Target Address
00**
01**
10**
Using address numbers only: 600 locations. Using the numeric keypad in combination with
address numbers: 600 locations.
is set to [Validate entry after a fixed time] in the System Administration mode, and for
example when you enter "**", "0" is automatically added to the beginning of the wildcards to
display "00**". For more information, refer to "5 Tools" > "Common Service Settings" >
"Other Settings" > "Auto Validation of Speed Dial Entry" in the Administrator Guide.
following is not available: "*100", "**10", and "1*00"
touch buttons. Select either of the following. By default, [Type 1] is selected.
• [Type 1]
The buttons 1 to 70 are used for address numbers and they correspond to the registered
address numbers 0001 to 0070, while the buttons 71 and 72 are used for stored programs
and they correspond to the registered stored programs 1 and 2.
• [Type 2]
The buttons 1 to 60 are used for address numbers and they correspond to the registered
address numbers 0001 to 0060, while the buttons 61 to 72 are used for stored programs
and they correspond to the registered stored programs 1 to 12.
• The Large Size UI (optional) does not support the one touch buttons.
The Number of Target
Numbers
0001 - 0099
0100 - 0199
1000 - 1099
<Speed Dial> button
Fax/Internet Fax
Addresses
99
100
100
201
4