Epson AcuLaser C2600 Service Manual page 247

EPSON AcuLaser C2600/2600
4.5.2.9 HOUSING, CONTROLLER
1. Remove the 4 screws that secure the COVER HOUSING, CONTROLLER, UNIT
to remove the COVER HOUSING, CONTROLLER, UNIT.
C.C.S-TITE SCREW,3x8,F/Uc: 4
2. Looking from the angle shown in the drawing, stretch the center of the right edge
of the HOUSING, CONTROLLER, slide the COVER ASSY., CONTROLLER
toward right until it is lifted onto the rib of the HOUSING, CONTROLLER, and
release the two tabs on the left side of the COVER ASSY., CONTROLLER.
3. Looking from the angle shown in the drawing, lift up the left side of the COVER
ASSY., CONTROLLER to release the 2 tabs at the right side, and remove the
HOUSING, CONTROLLER.
Disassembly and Assembly
2-3
2-3
HOUSING,CONTROLLER
Figure 4-38. Removal of HOUSING, CONTROLLER
Disassembling/Assembling the Main Unit
COVER HOUSING,
CONTROLLER, UNIT
1-1
1-1
1-2
1-1
1-1
Figure 4-37. Removal of COVER HOUSING, CONTROLLER,UNIT
3
3
Revision B
04002501
COVER ASSY., CONTROLLER
2-1
2-2
Rib
04002601
247