Epson AcuLaser C2600 Service Manual page 187

EPSON AcuLaser C2600/2600
Initial Check 2
W A R N I N G
Operating the printer with its interlock forcibly unlocked is
required for the procedures given below. Be extremely careful with
the following.
Perform the work with due attention to the laser beam so as
not to get the beam directly onto your body.
When unlocking the interlock with a driver or similar tool, be
careful not to apply excessive force or the interlock may be
damaged.
1. Turn the printer off.
2. Open the Cover A, and unlock the interlock by pushing the point indicated in
the figure with a driver or similar tool.
3. With the Cover A opened, turn the interlock switch on by inserting a driver
into the place shown in the figure while pressing the Cover B with your hand.
4. Turn the printer on with the interlock switch is on.The printer starts a
calibration cycle.
5. Lower the 2ND TRANSFER Assy., ASP and check the toner patch created on
the transfer belt to know when the belt stops (which color patch is created).
Troubleshooting Printing-quality troubleshooting (PQT)
3-1
5-1
2, 3-2
Figure 3-2. Initial Check
Revision B
03002901
187