EPSON AcuLaser C2600/2600
2.4.6 Fan
Table 2-7. List
Fig.
Name
1
Ozone Fan
Transfer the toner dispersed in the "development" process to the filter.
2
Toner Fan
Introduces the air into the printer to generate an air stream that goes
through the Photoconductor Unit and its duct with operation of the
Ozone Fan. The airstreams allow the printer to take ozone, which is
created in the drum charging process, out of the printer via the filter.
3
Power Supply Fan
Generates an air stream that goes over the LVPS to cool it. And the
exhausted air cools the Rotary Drive Motor and Developer Motor by
going through over them.
4
Fuser Fan
The upper part
Exhausts a hot air created by the Fuser Unit through the duct on the
upper and rear on the unit.
The lower part
Exhausts a hot air created by the Main Drive Motor and the
Photoconductor Drive Motor which are located behind the main
and engine controller boards.
Toner Fan
Figure 2-51. Ozone Fan / Toner Fan
Operating Principle
Function
Ozone Fan
02005701
Electrical
Power Supply Fan
Figure 2-52. Power Supply Fan
Figure 2-53. Fuser Fan
Revision B
02005801
Fuser Fan
02005901
124