Fitting The Profile Rails - Buderus Logano G615 Installation And Service Instructions Manual

7
Boiler block assembly

7.10.2 Fitting the profile rails

B Place top front profile rails onto the cast lugs and
screw in place with machine screws (M8 × x 12). The
folded edge on the front profile rail must face forward.
B Place top rear profile rails onto the cast lugs and screw
in place with machine screws (M8 × x 12). The folded
edge of the rear profile rail must face rearward.
B Place the side profile rails from the side on the front and
rear profile rails and screw on with self-tapping screws.
The folded edge of the side profile rails must point
towards the rear, while the oval holes must be
positioned towards the center of the boiler.
2 3
Fig. 36 Fitting front, rear, and side profile rails
1 Cast lugs
2 Side profile rail
3 Front profile rail (top front)
4 Rear profile rail (top rear)
5 Side profile rail
6 Cast lugs
32
B Attach the bottom front and rear profile rails onto the
feet of the end sections using machine screws.
4
5
6
Fig. 37 Fitting the lower profile rails
1 Front profile rail (bottom front)
2 Rear profile rail (bottom rear)
B Place the bottom side profile rails with the folded
edges towards the inside and the oval hole towards the
rear of the boiler from the side on the front and rear
profile rails and screw on using self-tapping screws.
B Push rear section thermal insulation onto the breach.
The cut-out for the boiler return must point upward.
B Attach the rear section thermal insulation to the rear
6 720 642 625-33. o
profile rail with two spring hooks.
Logano G615 - Subject to technical modifications
2
6 720 642 625-34. o