Buderus Logano G615 Installation And Service Instructions Manual page 37

B Push front top cover marked "A" with the hook in the
slots of the side profile rail and push forward.
B Screw back of top cover "A" to each side profile rail
using one self-tapping screw.
2
Fig. 45 Fitting the front top cover "A"
1 Hook
2 Slots in side profile rail
B Push 15 3/4 inches (400 mm) wide top cover marked
"D" with the folded edge under the front top cover.
2
Fig. 46 Fitting top cover "D"
1 Front top cover
2 Top cover "D"
Before the remaining top covers are put in
place, the control panel must be fitted, the
capillary tubes fed to the sensor wells and
the sensors placed in the sensor wells (see
Chapter 9.1, page 39).
Logano G615 - Subject to technical modifications
B Screw the top rear boiler to the back of the rear most
top cover and side panels.
B Screw the bottom rear boiler with the cut-out for the fill
and drain connection down onto the side panels.
6 720 642 625-4 . o
Fig. 47 Fitting the top and bottom boiler rear panels
1
2
B Screw the left or right front panel with four machine
screws to the cast lugs of the burner door.
B Hook burner door panel into the cut-outs in the front
cover.
6 720 642 625-42. o
Fig. 48 Fitting the left and right front panels
1
Boiler block assembly
Top rear boiler
Bottom rear boiler
Burner door panel
7
2
6 720 642 625-43. o
6 720 642 625-44. o
37