Buderus Logano G615 Installation And Service Instructions Manual page 33

B Close the slot below the flue outlet with spring hooks.
5
Fig. 38 Fitting lower side profile rails and thermal
insulation
1 Rear profile rail
2 Rear section thermal insulation
3 Spring hooks
4 Bottom side profile rail
5 Bottom side profile rail
B Push rectangular thermal insulation onto the front top
profile rail.
B Fasten thermal insulation with 3 spring hooks.
B If a burner cable is used, now would be the time to
route it on the outside of the insulation.
There are advantages to routing the burner
cable underneath the boiler jacket. To
prevent damage to the burner cable while
opening the burner door, the burner cable
must always be fed down the hinge side.
Logano G615 - Subject to technical modifications
2
4 3
6 720 642 625-35. o
Boiler block assembly
1
Fig. 39 Fitting the rectangular thermal insulation and
burner cable (installation optional)
1 Thermal insulation
2 Spring hooks
3 Burner cable (installation optional)
B Attach strain relief for the burner cable depending on
the door hinges left or right, to the bottom profile rail
( Fig. 40 – for burner door hinge right).
B Push the front base panel from the front onto the
bottom side profile rail and screw together.
7
3
4
6 7 0 64 6 5-36.1o
33