Configuring Sip And T.38; Restoring Sip And T.38 Factory Defaults; Sip And T.38 Parameters - Multitech FaxFinder FF240-IP Administrator's Manual

Configuring SIP and T.38

Configure SIP and T.38 with the parameters required by your IP network.
1. Click Fax Configuration. SIP/T.38 is the default page.
2. Enter SIP and T.38 parameters as required by your network.
3. Click Save.

Restoring SIP and T.38 Factory Defaults

To restore the factory settings for SIP and T.38, click Defaults. Note that factory defaults may not work with your
network.

SIP and T.38 Parameters

Field
SIP
Transport Protocol
Local Port
SIP Proxy/Gateway
SIP Proxy Port
SIP Domain
Loose Routing
Firewall Address
Authorization
Required
Use Registrar
Username
Registrar
Password
Registrar Port
Confirm Password
Expires
T.38
Fax ID
Max Rate
®
FaxFinder FF240-IP Administrator Guide
Description
SIP call setup messages are transmitted using UDP.
Enter the local port used for SIP. Default is 5060.
Enter the IP address of the SIP device that FaxFinder will communicate with when sending
faxes. It can be a SIP proxy, SIP Gateway or IP PBX.
Enter the SIP Proxy port, if required. Default is 5060.
Enter the SIP domain into the box, if required.
Select on if your network allows loose source routing. Default is off, used if your network
requires strict source routing.
Enter the IP address of your firewall so that FaxFinder can send and receive faxes through
your network.
Check this if the SIP proxy or the registrar requires authentication to communicate with
the FaxFinder.
Check this if the FaxFinder needs to use a Registrar for SIP call routing.
If you checked Authorization Required, enter the required username.
If you checked Use Registrar, enter the SIP Registrar IP address.
If you checked Authorization Required, enter the required password.
If you checked Use Registrar, enter the Registrar port. Default is 5060.
Re-enter the authorization password.
If you checked Use Registrar, enter the registrar expiration time in seconds. Default is
3600 seconds.
Enter the Fax ID you want the FaxFinder to send out.
Select the maximum fax transmission rate for the channels from the drop-down list.
Options are: 2400, 4800, 9600, 12000, 14400, 16800, 19200, 21600, 24000, 28800, 31200,
33600. Default is 14400.
BASIC FAXFINDER CONFIGURATION
21