Picture In Picture (Pip) - Barco PHWU-81B User And Installation Manual

3. Press ENTER key.
The screen is split in two and the left and right screens display the following images:
Left Image supplied to the last selected input source, VGA (COMPUTER1), 5BNC (COMPUTER2), DVI, HDMI or
screen SDI (for PHWU-81B only)
Right
Image supplied to the last selected input source, VIDEO or S-VIDEO
screen
Important
• When you press the MENU key, the screen is displayed in the normal mode.
• Also, when you change the input source, the screen is displayed in the normal mode.
• In the split mode, the picture quality settings of the input source in the normal mode to be displayed on the left screen are
reflected on the entire screen.
• When no signal is input, a blue screen is displayed.
• When you input an interlace signal to the left screen, the displayed image may shake up and down slightly, but this is not a
malfunction.
• When you display 60-Hz and 50-Hz video signals at the same time, motion images may not be displayed properly. In this case,
set VERT. SYNC. of USER in the SIGNAL menu to OFF for the left screen.
• You cannot use the split mode unless a signal is being input.
• Displaying the screen split in two may take some time depending on the signal.
To change the input source of the left or right screen:
• To change the input source of the left screen, press the ◄ key on the remote control. Each time the the ◄ key is pressed, the
input source setting changes in order of VGA (COMPUTER 1) → 5BNC (COMPUTER 2) → DVI → HDMI → SDI (for PHWU-
81B only) → VGA (COMPUTER 1) ....
• To change the input source of the right screen, press the ► key on the remote control. Each time the the ► key is pressed, the
input source setting changes in order of VIDEO → S-VIDEO → VIDEO ....
9.3

Picture in Picture (PIP)

for PHXG- 91B only
About Picture in Picture
One of the special features of this projector is the picture-in-picture (PIP) mode. The PIP mode allows you to view the images from
different sources at the same time.
While viewing the image from the VGA (COMPUTER1), 5BNC (COMPUTER2), DVI, or HDMI input source, you can display the
image from the VIDEO or S-VIDEO input source as a sub image.
Image 9-6
A Sub image
To use the PIP mode:
1. Display the INSTALLATION 1 menu in the ADVANCED MENU.
2. Select PIP.
3. Press ENTER key.
Sub image is displayed.
R5905597 PHXX SERIES 20/05/2014
A
9. Advanced features
87