Table of Contents
Advertisement
Item
USER
CLAMP POSITION
CLAMP WIDTH
VERT. SYNC.
LPF
SHUTTER(U)
SHUTTER(L)
SHUTTER(LS)
SHUTTER(RS)
•
Though horizontal strips may appear on the enlarged projected image, such symptom is not a malfunction.
•
When you change the horizontal or vertical position to a large extent, noise may appear
•
The adjustable range of the vertical position varies depending on the type of the input signal. Though the image may stay in
the same position even when the setting value is changed, such symptom is not a malfunction.
•
When you increase the setting value of OVER SCAN, noise may appear on the screen.
•
When 16:9 is selected by SCREEN, you cannot set ASPECT to 16:9.
•
When 4:3 is selected by SCREEN, you cannot set ASPECT to 4:3.
•
ASPECT-USER setting supports the COMPUTER1, COMPUTER2, DVI, and HDMI terminals only. Therefore, you cannot se-
lect USER for other terminals.
You can set the IMAGE menu and the SIGNAL menu only when the signal is supplied.
5.9
NETWORK menu
Overview
IMAGE INSTALL1 INSTALL2 MULTI-
SCREEN FEATURE SIGNAL
PROJECTOR NAME
NETWORK
CERTIFICATION
NETWORK
PASSWORD
IP CONFIG
CONTROL SYSTEM
NETWORK RESET
NETWORK RESTART
Image 5-19
Item
PROJECTOR NAME
R5905597 PHXX SERIES 20/05/2014
Setting
4:3
USER
ENTER
1-255
1-63
AUTO / OFF
ON / OFF
0-259 (for PHWU-81B) /
0-142 (for PHWX-81B) /
0-126 (for PHXG-91B
0-259 (for PHWU-81B) /
0-142 (for PHWX-81B) /
0-126 (for PHXG-91B)
0-311 (for PHWU-81B) /
0-192 (for PHWX-81B) /
0-128 (for PHXG-91B)
0-311 (for PHWU-81B) /
0-192 (for PHWX-81B) /
0-128 (for PHXG-91B)
NETWORK
INFO
OFF
ENTER
ENTER
STANDARD
OK
OK
Setting
*****...
Function
Regardless of the type of input signal, image is displayed at 4:3
aspect ratio.
Displays the detailed settings.
The USER menu is displayed for the following adjustments.
Use to correct solid white or solid black in the projected image.
Use to correct solid black in the projected image.
Use to adjust the image when its motion doesn't run smoothly. Select
AUTO for normal use.
Use to select whether or not to enable the LPF.
Use to adjust the image when noise appears on the top part of the
image.
Use to adjust the image when noise appears on the bottom part of
the image.
Use to adjust the image when noise appears on the left half of the
image.
Use to adjust the image when noise appears on the right half of the
image.
IMAGE INSTALL1 INSTALL2 MULTI-
SCREEN FEATURE SIGNAL
IP CONFIG
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT GATEWAY
MAC ADDRESS
SAVE SETTINGS
Function
Set the name to identify the projector. Enter up to 15 characters
(alphabets or numeric characters).
5. Advanced menu
NETWORK
INFO
ON
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
OK
51
Advertisement
Table of Contents
