Table of Contents
Advertisement
7. Initial network settings
→ The setting change dialog is displayed. After the dialog disappears, the NETWORK menu is displayed.
→ It may take some time to reflect the settings.
7.5
Setting the control system
How to set
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select CONTROL SYSTEM.
CONTROL SYSTEM
Image 7-19
3. Press the ENTER key.
CONTROL SYSTEM
:
OK : ENTER CANCEL : MENU
Image 7-20
4. Press the ◄ or ► key to select STANDARD
STANDARD
AMX
CRESTRON
Important: PJLink™ works regardless of the setting of CONTROL SYSTEM.
5. Press the ENTER key.
It may take some time to reflect the settings.
7.6
Initialization of Network Settings
How to initialize
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select NETWORK RESET.
NETWORK RESET
Image 7-21
3. Press the ENTER key.
Confirmation dialog appears.
4. Press the ENTER key again, and the Network Settings can be initialized (except for IP CONFIG).
To cancel the initialization, press the MENU key.
It may take some time to reflect the settings.
7.7
How to Use Network Function
Overview
•
When connecting a computer and projector with LAN, configure the both IP Addresses in the same network group.
If connecting in different network group, be sure to use a router. As for the settings of a router, ask the network administrator.
•
Configure the IP CONFIG correctly. If the settings are not correct, the communication may be unavailable. For the detail,
consult the network administrator.
•
Depending on the settings of standby mode of the projector, LAN function may be unavailable.
80
STANDARD
STANDARD
, AMX , or CRESTRON
Select this setting when using Projector Toolset, or RS-232C commands via LAN terminal.
Select this setting when using the controller of AMX.
Select this setting when using the controller or software of Crestron Electronics, Inc.
OK
.
R5905597 PHXX SERIES 20/05/2014
Advertisement
Table of Contents
