Table of Contents
Advertisement
Item
GEOMETRY
TEST PATTERN
SPLIT (for PHWU-81B/
PHWX-81B only)
PIP (for PHXG-91B only)
AUTO POSITION
•
Regardless of the setting of LAMP MODE, the STANDARD lamp mode is activated by default whenever the projector is turned
on. When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW about 2 minutes after turn-on.
•
When the ambient operating temperature is high, the brightness of the lamp isn't changed by switching the lamp mode.
•
When the lamp mode is switched, the projected image may flicker.
•
Frequent switching of the lamp mode may damage the lamp.
•
When using the projector for a long time, set LAMP RELAY.
•
While the lamps are being warmed up, an icon is displayed to the right of the INSTALLATION 1 menu bar. While the icon
is being displayed, you cannot set LAMP SELECT and LAMP RELAY. And an icon is displayed while the operating ambient
temperature is high. While the icon is being displayed, the lamp may not brighten even when you change the LAMP MODE to
STANDARD.
•
After you switch the lamps and the newly selected lamp turns on, you cannot turn off the projector for approx. 1 minute.
5.5
Installation 2 menu
Overview
MULTI-
IMAGE INSTALL1
INSTALL2
SCREEN FEATURE SIGNAL NETWORK
AUTO POWER ON
AUTO POWER OFF
SCREEN
IMAGE CAPTURE
SPLASH SCREEN
BACK COLOR
DVI LONG CABLE
REMOTE 1 MODE
FILTER MENU
Image 5-15
Item
AUTO POWER ON
AUTO POWER OFF
SCREEN
IMAGE CAPTURE
SPLASH SCREEN
BACK COLOR
R5905597 PHXX SERIES 20/05/2014
Setting
ENTER
ENTER
ENTER
ENTER
ENTER
INFO
OFF
5min
16:10
SETUP
ON
IMAGE
AUTO
ENTER
ENTER
Setting
ON / OFF
OFF / 5min-8hour
16:10 (For PHWU-
81B/PHWX-81B only)
16:9
4:3
SETUP
ON
BLUE / BLACK / IMAGE
Function
The geometry adjustment menu is displayed.
The test pattern is displayed.
The split screen is displayed.
The picture-in-picture (PIP) screen is displayed.
The auto position function is activated.
Function
When ON is chosen, the projector is automatically turn on when the
power cord is plugged in the wall outlet. Choose ON when using the
projector mounted on the ceiling.
→ The projector is in the stand-by mode when the lamp is off. Use the
remote control to turn on the lamp.
When no video signal is input and no operation is made, the projector
automatically turns off after the selected time period. A dialog is
displayed 5 minutes before the projector turns off.
Select this setting when using a 16:10 screen.
Select this setting when using a 16:9 screen.
Select this setting when using a 4:3 screen.
This projector does not support this function.
Fixed to ON.
Use to select the background from among BLUE, BLACK and IMAGE,
which will be displayed when there is no signal input from the source.
When IMAGE is selected, the splash image will be displayed.
5. Advanced menu
45
Advertisement
Table of Contents
