Table of Contents
Advertisement
6. Adjustments with the ADVANCED menu
Image 6-32
When you press the ◄ or ► key in the RESET mode, the distortion correction is reset.
Important
•
When the CURVED-mode adjustment takes effect, the resolution decreases. In addition, stripes may appear or straight lines
may bend in images with complicated patterns. They are not due to product malfunctions.
•
When the CURVED-mode adjustment is performed, the displayed image may be distorted.
•
Depending on the installation conditions of the projector and the screen or the correction amount of the CURVED-mode adjust-
ment, you may not obtain a complete rectangular screen or the correct aspect ratio. Slight distortion can be corrected by the
CORNERSTONE-mode adjustment.
•
Noise may appear on the screen during the CURVED-mode adjustment because of the type of the video signal being projected
and the setting values of the CURVED-mode adjustment. In such cases, set the CURVED-mode adjustment values in the range
where the image is displayed without noise.
•
When you carry out the KEYSTONE-mode adjustment and the CURVED-mode adjustment in combination, the adjustment
range becomes narrower than that in the case where you carry out these adjustments individually. When setting the arc setting
value of the CURVED-mode adjustment to 31 or larger, you cannot use the KEYSTONEmode adjustment.
•
When carrying out the CURVED-mode adjustment while the option lens is in use, you may not be able to obtain a perfectly
rectangular image or the correct aspect ratio. Slight distortion can be corrected by the CORNERSTONE-mode adjustment.
6.20 Changing the AUTO POWER OFF setting
About
The AUTO POWER OFF function of this projector is enabled by default. Change the AUTO POWER OFF setting as necessary.
How to change
1. Display the INSTALLATION 2 menu.
2. Select AUTO POWER OFF by pressing the ▲ or ▼ key.
AUTO POWER OFF
Image 6-33
3. Select your desired item by pressing the ◄ or ► key.
6.21 Setting IMAGE REVERSE
Overview
•
Set IMAGE REVERSE in the INSTALLATION 1 menu according to the orientation of the projector. The default setting is OFF.
•
Select OFF for the combination of floor installation and front projection.
•
Select MIRROR INVERT for the combination of ceiling installation and front projection.
•
Select MIRROR for the combination of floor installation and rear projection.
•
Select INVERT for the combination of ceiling installation and rear projection.
72
5min
R5905597 PHXX SERIES 20/05/2014
Advertisement
Table of Contents
