How To Clean The Automatic Cleaning Filter - Barco PHWU-81B User And Installation Manual

- The value of each item is out of the setting range.
D
H
8. Select OK to accept the interval you entered and exit the menu, or select CANCEL to exit the menu without saving the setting.
When you select OK or CANCEL, the CLEANUP PERIOD menu is displayed.
11.3.2 How to clean the automatic cleaning filter
Preparations
Check the amount of dust through the dust check window of the filter cover and clean it, if necessary. Before cleaning the filter, be
sure to unplug the power cord from the outlet.
• Wen the dust box of the automatic cleaning filter is filled up with dust, the cleaning ability decreases. If you use the projector
in such a state, the filter is covered by the dust and the temperature inside the product abnormally rises, damaging the internal
parts and components and affecting the panel's lifetime, resulting in a breakdown.
• When the temperature inside the projector is abnormally high, the projector may automatically turn off and go into the standby
mode where the light source lamps are off to protect the internal parts and components.
C
AUTION
How to clean
1. Loosen two screws (a) on the rear and two screws (b) on the side that are securing the side cover (c) using a Phillips screwdriver.
(c)
(b)
Image 11-5
2. Slide and remove the side cover towards the rear.
Image 11-6
3. Remove the automatic cleaning filter.
R5905597 PHXX SERIES 20/05/2014
8 or over (1 WEEK only)
7D 01H or over
:
Only authorized service personnel are allowed to remove the covers.
(a)
11. Maintenance
101