Table of Contents
Advertisement
5. Advanced menu
Item
DVI LONG CABLE
REMOTE 1 MODE
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
PIN 9
RESET
FILTER MENU
CLEANUP PERIOD
MANUAL CLEANUP
•
When STANDBY MODE in the INSTALLATION 1 menu is LOW, you cannot select REMOTE 1 MODE.
5.6
Multi-Screen menu
Overview
MULTI-
IMAGE INSTALL1 INSTALL2
SCREEN
EDGE BLENDING
SETTING
COLOR MATCHING
MANUAL
MEASURE
Image 5-16
Item
EDGE BLENDING
SETTING
46
Setting
AUTO
MANUAL
ENTER
GND
POWER / NONE
COMPUTER 1
COMPUTER 2
VIDEO
S-VIDEO
DVI
BLANK / NONE
ON/OFF
OK
ENTER
24H
/ 1 WEEK
/ OFF
OK
FEATURE SIGNAL NETWORK
INFO
OFF
EDGE ADJUST
OFF
SETTING
MEASURED DATA
Setting
OFF
ON
EDGE ADJUST
BLACK LEVEL
BRIGHT UNIFORMITY
CORRECTION
Function
Select this option for normal use.
Use to adjust the amount of transmission signal correction when a
long DVI cable is used.
Select when controlling the projector by a control panel connected to
the REMOTE 1 IN terminal.
Unchangeable. (Fixed.)
Select POWER or NONE.
You can assign COMPUTER 1, COMPUTER 2, VIDEO, S-VIDEO,
DVI, HDMI, SDI (for PHWU-81B only), or NONE to each pin. Though
the assignment can be duplicated, the pins so assigned become
invalid and their settings are displayed with asterisks at both ends
(like "*COMPUTER 1*").
Select BLANK or NONE.
Unchangeable. (Fixed.)
Settings are reset to the defaults.
The filter menu for the following settings is displayed.
You can set the filter cleaning interval.
Select this option to clean the filter immediately.
Function
Select when using the projector alone
Select when using the projector to configure the multi-screen
consisting of multiple projectors.
The following settings in the SETTING become enabled to make the
overlapped area of the displayed images unnoticeable.
Use to make the overlapped area of the screens unnoticeable in the
multi-screen application. Use this setting to select the edges to be
overlapped or to set the overlapped areas.
In the multi-screen application, the black level in the areas where
images are overlapped will become bright. So, use this setting to
adjust the black level in non-overlapped areas.
Use to correct non-uniformity in the screen brightness of the single
projector to facilitate edge blending.
R5905597 PHXX SERIES 20/05/2014
Advertisement
Table of Contents
