Installation 1 Menu - Barco PHWU-81B User And Installation Manual

5. Advanced menu
5.4

Installation 1 menu

Overview
INSTALL2 MULTI-
IMAGE INSTALL1 SCREEN FEATURE SIGNAL NETWORK
LAMP MODE
LAMP SELECT
LAMP RELAY
STANDBY MODE
IMAGE REVERSE
HIGH ALTITUDE MODE
LENS LOCK
GEOMETRY
TEST PATTERN
SPLIT
AUTO POSITION
Image 5-14
Item
LAMP MODE
LAMP SELECT
LAMP RELAY
STANDBY MODE
IMAGE REVERSE
HIGH ALTITUDE MODE
LENS LOCK
ZOOM/FOCUS LOCK
LENS SHIFT LOCK
LENS SHIFT RESET
44
INFO
STANDARD
DUAL
1H/24H
LOW
OFF
STANDARD
ENTER
ENTER
ENTER
ENTER
ENTER
Setting
STANDARD
LOW
DUAL
SINGLE
LAMP 1
LAMP 2
DUAL: OFF
DUAL: 1H/24H / 2H/1W
SINGLE: OFF
/ 1 WEEK Use to set the lamp relay interval.
SINGLE: 24H
STANDARD
LOW
OFF
MIRROR
INVERT
MIRROR INVERT
STANDARD
ENTER
ON / OFF
ON / OFF
OK
INSTALL2 MULTI-
IMAGE INSTALL1 SCREEN FEATURE SIGNAL NETWORK
LENS LOCK
ZOOM/FOCUS LOCK
LENS SHIFT LOCK
LENS SHIFT RESET
Function
Select to optimize the settings automatically depending on the input
signal. (Select this option for normal use.)
Select to moderate the intensity of the lamp. The operating sound is
reduced and the lamp lifetime becomes longer.
LAMP 1 and LAMP 2 illuminate.
The lamp with shorter operation time is automatically selected at
power‑on.
LAMP 1 illuminates. (When it is broken or dead, LAMP 2 illuminates
automatically.)
LAMP 2 illuminates. (When it is broken or dead, LAMP 1 illuminates
automatically.)
The LAMP RELAY doesn't work.
Use to set the lamp relay interval.
The LAMP RELAY doesn't work.
Select this option when you control the projector via the LAN,
REMOTE 1 IN, and SERIAL OUT terminal during power standby.
Select this option when you don't control the projector via the LAN,
REMOTE 1 IN, and SERIAL OUT terminal during power standby. This
option disables the LAN, REMOTE 1 IN, and SERIAL OUT terminal
and reduces the power consumption during the power standby.
Select when viewing images from the front with the projector installed
on the floor.
Select when viewing images projected from the behind of the screen
with the projector installed on the floor.
Select when viewing images projected from the behind of the screen
with the projector installed on the ceiling.
Select when viewing images from the front with the projector installed
on the ceiling.
This projector does not support this function.
The LENS LOCK menu is displayed for the following settings.
Use to enable or cancel the FOCUS LOCK and ZOOM LOCK.
Use to enable or cancel the LENS SHIFT LOCK.
Use to reset the position of the lens to the factory setting.
INFO
OFF
OFF
OK
R5905597 PHXX SERIES 20/05/2014