Simple Method To Adjust The Image Position; Lpf (Progressive Filter); Image Displayed On The Multi-Screen, Joints - Barco PHWU-81B User And Installation Manual

6. Adjustments with the ADVANCED menu
The projected image is displaced horizontally.
The projected image is displaced vertically.
The top part of the image flags.
A solid black or solid white appears in the image.
The motion doesn't run smoothly.
Noise appears on the right or left half of the image.
Noise appears on the top or bottom part of the image.
Do not change the settings of the SIGNAL menu in normal use.
How to adjust
1. Display the SIGNAL menu.
2. Press the ▲ or ▼ key to select an item to adjust.
3. Adjust the selected item by pressing the ◄ or ► key.
4. To cancel the menu, press the MENU key.

6.14 Simple method to adjust the image position

To adjust the horizontal position
1. Align the left edge of the image with the left side of the screen by adjusting HORIZ. POSITION. Then, align the right edge of the
image with the right side of the screen by adjusting TRACKING.
2. Repeat step 1 above to complete the adjustment of the horizontal position.
To adjust the vertical position
1. Align the upper edge of the image with the upper side of the screen by adjusting VERT. POSITION.
6.15 LPF (Progressive filter)
About LPF
You can select whether or not to enable the LPF. Vertical or horizontal streak noise may appear on the projected image, depending
on the type of the DVD player or game console you use. In such a case, you can reduce such streak noise by enabling the LPF.
However, projected images become softened slightly.

6.16 Image displayed on the multi-screen, joints

About multi-screen
You can configure a multi-screen display using multiple projectors.
You can make the joints of the images displayed on the projectors unnoticeable and adjust the differences in the brightness and the
color tint of them.
Important: Depending on the installation condition, the projected image may fluctuate due to the effect of the exhausted wind. In
such a case, open up the space between the projectors so that the image doesn't fluctuate (approximately 70 cm or more).
You can make the joints of the images projected on the projectors unnoticeable using the menu settings.
Making the joints unnoticeable
1. Display the MULTI-SCREEN menu.
64
Adjust HORIZ. POSITION in the SIGNAL menu. Every time the
◄ key is pressed, the image moves to the right. Every time the
► key is pressed, the image moves to the left.
Adjust VERT. POSITION in the SIGNAL menu. Every time the
◄ key is pressed, the image moves down. Every time the ►
key is pressed, the image moves up.
Change the setting of HOLD in the SIGNAL menu. Select
ON , press the ENTER key, and adjust BEGIN or END to
minimize the flagging.
Adjust CLAMP POSITION or CLAMP WIDTH in the SIGNAL -
USER menu.
Adjust VERT. SYNC. in the SIGNAL - USER menu. Select
AUTO for normal use.
Adjust SHUTTER(LS) or SHUTTER(RS) in the SIGNAL -
USER menu.
Adjust SHUTTER(U) or SHUTTER(L) in the SIGNAL - USER
menu.
R5905597 PHXX SERIES 20/05/2014