Toshiba e-studio600 Service Manual page 72

Classi-
Code
fication
356 RADF Automatic adjustment of
RADF sensor
357 RADF Fine adjustment of RADF
transport speed
358 RADF RADF sideways deviation
adjustment
359 Scanner Carriage position adjust-
ment during scanning from
RADF
365 RADF RADF lead-
ing edge posi-
tion
adjustment
366
367 RADF RADF original guide width
adjustment
(Minimum)
368 RADF RADF original guide width
adjustment
(Maximum)
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
Adjustment mode (05)
Func-
Items
tion
ALL
ALL
ALL
ALL
for single - ALL
sided orig-
inal
for double ALL
sided orig-
inal
ALL
ALL
2 - 48
Default
<Accept-
RAM
able
value>
- SYS Performs the adjustment
and initialization when
the RADF board or
RADF sensor is
replaced.
50 SYS When the value
<0-100> increases by "1", the
reproduction ratio of the
secondary scanning
direction when using the
RADF increases by
approx. 0.1%.
120 SYS When the value
<0-255> increases by "1", the
image of original fed
from the RADF shifts
toward the rear side of
paper by approx.
0.0846 mm.
128 SYS When the value
<0-255> increases by "1", the car-
riage position when
using the RADF shifts by
approx. 0.1 mm toward
the original feeding side.
50 SYS When the value
<0-100> increases by "1", the
copied image of original
fed from the RADF shifts
50 SYS
toward the trailing edge
<0-100>
of paper by approx.
0.1 mm.
- - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
minimum width. Perform
this adjustment when the
RADF board or volume is
replaced, or when the
code (05-352) is per-
formed.
- - Stores the current width
of RADF original guide
by keying in this code
with the guide set at the
maximum width. Per-
form this adjustment
when the RADF board or
volume is replaced, or
when the code (05-352)
is performed.
Proce-
Contents
dure
6
1
1
1
1
1
6
6
March 2005 © TOSHIBA TEC