[C] Assembling carriage wires (Winding the wire around the wire pulley)
<Procedure>
(1)
Pull the Ø3 ball terminal located at the center of the wire into a hole on the wire pulley. One end
of the wire with a hook attached comes to the outside.
(2)
Wind the wires around the wire pulleys of the front and rear sides. The number of turns to be
wound are as follows:
•
2 turns toward the opposite side of the boss
•
5 turns toward the boss side
Note:
Note:
Pay attention to the following when the wires are wound around the pulleys:
-
Do not twist the wire.
-
Wind the wires tightly so that they are in complete contact with the surface of the pulleys.
-
Each turn should be pushed against the previously wound turn so that there is no space
between them.
2 turns
Ball terminal
Hook
March 2005 © TOSHIBA TEC
5 turns
No space between turns
Color: Silver
[ Rear ]
Fig.3-31
3 - 39
5 turns
2 turns
Ball terminal
Color: Black
[ Front ]
e-STUDIO520/600/720/850 ADJUSTMENT
3
Hook