Adjustment Of The Paper Feeding System - Toshiba e-studio600 Service Manual

3.8

Adjustment of the Paper Feeding System

3.8.1 Sheet sideways deviation caused by paper feeding
<Procedure>
The center of the printed image shifts to the front
side. -> Move the guide to the front side when
feeding paper from the bypass tray or the drawer.
Move the front cover to the rear side when feed-
ing paper from the Tandem LCF. (Arrow (A) direc-
tion in the lower figure).
Feeding direction
Fig.3-39
Bypass feeding
1) Loosen the screen.
2) Move the entire guide to the front or rear side.
3) Tighten the screw.
( A ) ( B )
Fig.3-41
March 2005 © TOSHIBA TEC
[ Rear ]
Center
[ Front ]
3 - 45
05/04
The center of the printed image shifts to the rear
side. -> Move the guide to the rear side when
feeding paper from the bypass tray or the drawer.
Move the front cover to the front side when feed-
ing paper from the Tandem LCF. (Arrow (B) direc-
tion in the lower figure).
[ Rear ]
Feeding direction
[ Front ]
Fig.3-40
Drawer feeding
1) Loosen 2 screws.
2) Move the entire guide to the front or rear side.
3) Tighten the screws.
( B )
( A )
Fig.3-42
e-STUDIO520/600/720/850 ADJUSTMENT
3
Center