Toshiba e-studio600 Service Manual page 407

[CB40] Alignment motor (rear) abnormality
Is the alignment guide home position sensor (PI5S) working normally?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and the alignment motor (M5S) cor-
rect?
YES Æ Correct the wiring.
È
NO
Is there any mechanical problem with the alignment guide movement path?
YES Æ Fix the mechanism.
È
NO
Is the problem solved by replacing the alignment motor?
NO Æ
È
YES
END
[CB50] Staple motor abnormality
Is the wiring between the finisher controller PC board and the stapler normal?
NO Æ
È
YES
Is the problem solved by replacing the stapler?
YES Æ END
È
NO
Replace the finisher controller PC board.
March 2005 © TOSHIBA TEC
Replace the sensor.
Replace the finisher controller PC board.
Correct the wiring.
5 - 79
e-STUDIO520/600/720/850 TROUBLESHOOTING
5