Toshiba e-studio600 Service Manual page 408

[CB60] Stapler shift motor abnormality
Is the stapler shift home position sensor (PI7) working normally?
NO Æ
È
YES
Is the wiring between the finisher controller PC board and the stapler shift motor (M4) cor-
rect?
YES Æ Correct the wiring.
È
NO
Is there any mechanical problem with the stapler stand motion path?
YES Æ Fix the mechanism.
È
NO
Try replacing the staple shift motor. Is the problem corrected?
YES Æ END
È
NO
Replace the finisher controller PC board.
e-STUDIO520/600/720/850 TROUBLESHOOTING
Replace the sensor.
5 - 80
March 2005 © TOSHIBA TEC