Toshiba e-studio600 Service Manual page 30

Error code Classification
E721 RADF jam
E722
E723
E724
E725
E726
E728
E731
E732
E733
E741
E742
E743
E751
e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Original not reaching read sensor: An original which
has passed the original registration sensor (while its
front side is being scanned) or the reverse sensor
(while its back side is being scanned) does not
reach the read sensor.
Original not reaching large original exit sensor (dur-
ing scanning): An original which has passed the
read sensor does not reach the large original exit
sensor when this original is transported from the
scanning section to the exit section.
Original not reaching small original reverse sensor
(during scanning): An original which has passed the
read sensor does not reach the small original
reverse sensor when this original is transported
from the scanning section to the reverse section.
Original stopping at registration sensor: The trailing
edge of the original does not pass the registration
sensor after its leading edge has reached the regis-
tration sensor.
Original stopping at read sensor: The trailing edge
of the original does not pass the read sensor after
its leading edge has reached the read sensor.
Transport/exit signal reception jam: The RADF has
received the transport/exit signal from the equip-
ment while no original is at the exposure waiting
position.
Original not reaching small original exit sensor (dur-
ing scanning): An original which has passed the
read sensor does not reach the small original exit
sensor when this original is transported from the
scanning section to the exit section.
Original stopping at large original exit sensor: The
trailing edge of the original does not pass the large
original exit sensor after its leading edge has
reached the large original exit sensor.
Original stopping at small original exit sensor: The
trailing edge of the original does not pass the small
original exit sensor after its leading edge has
reached the small original exit sensor.
Original not reaching large original exit sensor (exit
section)
Original stopping at small original reverse sensor:
The trailing edge of the original does not pass the
small original reverse sensor after its leading edge
has reached the small original reverse sensor.
Original not reaching small original reverse sensor
(during reverse feeding): The leading edge of the
original does not reach the small original reverse
sensor when this original is fed out of the reverse
section.
Original not reaching small original exit sensor (dur-
ing reverse feeding): An original which has passed
the small original reverse sensor does not reach the
small original exit sensor when this original is exited
out of the reverse section.
Original stopping at original intermediate transport
sensor: The trailing edge of the original does not
pass the original intermediate transport sensor after
its leading edge has reached the original intermedi-
ate transport sensor.
2 - 6
Troubleshooting
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
Ch.5.1.4
March 2005 © TOSHIBA TEC