D Memory Bank Scan - Icom ID-5100A Full Manual

Previous view
4
SCAN OPERATION
Memory scan (Continued)

D Memory bank scan

A memory bank scan searches through the memory
channels in the selected bank.
• Two or more memory channels, which are not set as skip chan-
nels, must be programmed to start a memory bank scan.
• When the "Bank Select" item in the Quick Menu screen is
set to "OFF," a bank scan is not started.
Touch the Memory channel number.
q
• Opens the Mode setting window.
Touch [MR].
w
• Selects the Memory mode.
Touch the Function group icon one or more times.
e
• Selects the F-1 menu.
Touch [SCAN].
r
• Opens the scan type setting window.
Touch the desired scan type.
t
• ALL: Full bank scan
• BANK-LINK: Bank link scan
• BANK-A to Z: Bank scan
( Only banks which contain a memory chan-
nel are displayed.)
• DUP: Duplex scan (p. 4-2)
( Appears only when duplex is set on the
channel.)
• TONE: Tone scan (For tone scanning)
The scan starts.
y
• If desired, during a scan, rotate [DIAL] to switch the scan-
ning direction.
• The scan runs even while the Menu or Quick Menu screen
is displayed.
During a Memory bank scan
When receiving a signal
The S-meter shows the
received signal strength.
To cancel the scan, touch [SCAN].
u
• Touching the frequency readout also cancels the scan.
When a bank name is assigned.
When a bank name is assigned, the bank name is
displayed on the scan type setting window.
NOTE: The scan name is not displayed during a
scan.
NOTE:
• When all channels are set as "SKIP" or "PSKIP," the
bank will be skipped during a bank link scan.
• When all channels in the selected bank are set as
"SKIP" or "PSKIP," the scan does not start during a
bank scan.
4-9
Blinks
Blinks
Blinks
Blinks
Bank name