Power Assisted System (Power Steering)
(1)
Bush
(2)
Nut
(3)
21 mm
(4)
14 mm
(5)
Bolt
(2) Tighten bolt which installs oil pump to
bracket.
Tightening torque:
37.3 N·m (3.8 kgf-m, 27.5 ft-lb)
Tightening torque:
15.7 N·m (1.6 kgf-m, 11.6 ft-lb)
OIL PUMP
2) Tighten bolt which install power steering pump
bracket.
Tightening torque:
22 N·m (2.2 kgf-m, 15.9 ft-lb)
B4M1670B
3) Interconnect pipes C and suction hose.
Tightening torque:
Joint nut
39.2 N·m (4 kgf-m, 28.9 ft-lb)
CAUTION:
If a hose is twisted at this step, the hose may
come into contact with some other parts.
B4M2532
(1)
(2)
4) Connect connector to power steering oil pres-
sure switch.
5) Install pulley belt to oil pump.
6) Check pulley belt tension. <Ref. to ME(DOHC
TURBO)-45, INSPECTION, V-belt.>
7) Tighten bolt belt tension.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
B4M1660
8) Install pulley belt cover.
9) Install air intake boot.
10) Connect ground terminal of battery.
11) Feed the specified power steering fluid. <Ref.
to PS-101, Power Steering Fluid.>
CAUTION:
Never start the engine before feeding the fluid;
otherwise vane pump might be seized up.
PS-96
Suction hose
Pipe C
B2M3151
ST0017