Subaru 2001 FORESTER Service Manual page 95

Power Assisted System (Power Steering)
2. TURBO MODEL
1) Remove ground terminal from battery.
2) Remove intake duct. <Ref. to IN(DOHC
TURBO)-8, REMOVAL, Air Intake Duct.>
3) Remove pulley belt cover.
4) Loosen lock bolt and slider bolt and remove
power steering pump drive V-belt.
5) Disconnect connector from power steering
pressure switch.
6) Remove intake boot and air cleaner upper.
<Ref. to IN(DOHC TURBO)-7, REMOVAL, Air
Cleaner.>
7) Disconnect pipe C and suction hose from oil
pump.
CAUTION:
¼ Do not allow fluid from the hose end to come
into contact with pulley belt.
¼ To prevent foreign matter from entering the
hose and pipe, cover the open ends of them
with a clean cloth.
(1) Suction hose
(2) Pipe C
8) Remove bolts which install power steering
pump bracket.
S601070A1805
G2M0286
ST0017
OIL PUMP
9) Place oil pump bracket in a vise, remove two
bolts from the front side of oil pump.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
10) Remove bolt from the rear side of oil pump.
11) Disassemble oil pump and bracket by inserting
a screwdriver as shown in the figure.
PS-94
B2M3151
B4M1660
B4M1661