Subaru 2001 FORESTER Service Manual page 65

Power Assisted System (Power Steering)
13) Install holder from cylinder side of steering
body.
Tightening torque:
64 N·m (6.5 kgf-m, 47.0 ft-lb)
14) Attach ST to rack cylinder. Using a press,
install back-up ring and oil seal.
NOTE:
Press ST until its groove is aligned with end of
holder.
ST 34099FA030 INSTALLER & REMOVER
(1) Installer guide
(2) Holder
(3) Rack piston
(4) Oil seal
(5) Back-up ring
STEERING GEARBOX [RHD MODEL]
G4M0820
S4M0433A
PS-64
15) Using ST, clinch steering body cylinder at a
point less than 3 mm (0.12 in) from holder.
CAUTION:
Be careful not to deform holder.
ST 34099FA060 PUNCH
(1) Holder
16) Remove traces of sealer, oil, rust, etc., from
mating surfaces of valve housing and steering
body.
17) Position a shim in graded portion of steering
body pinion housing, and apply an even coat of
sealer (Fuji Bond C: 004403004) to end of pinion
housing.
(1) Shim
(2) Fuji Bond C (004403004)
18) Use the same number of shims as that used
when steering body was removed.
19) If steering body, valve housing or pinion and
valve is replaced with a new one, add two or three
shims, install valve on pinion housing and tighten
S4M0434A
S4M0435A