Power Assisted System (Power Steering)
7) Tighten adjusting screw until it no longer tight-
ens.
(1)
Adjusting screw
8) Using a wrench (32 mm width across flats) or
adjustable wrench, remove tie-rod.
CAUTION:
¼ Check ball joint for free play, and tie-rod for
bends. Replace if necessary.
¼ Check dust seals used with tie-rod end ball
joint for damage or deterioration. Replace if
necessary.
(1)
Tie-rod
9) Loosen adjusting screw and remove spring and
sleeve.
CAUTION:
Replace spring and/or sleeve if damaged.
STEERING GEARBOX [RHD MODEL]
S4M0392A
S4M0393A
PS-56
10) Disconnect pipes A and B from steering body
and control valve housing.
CAUTION:
Replace pipes and/or flare nuts if damaged.
(1)
Pipe A
(2)
Pipe B
11) Slide dust cover out.
CAUTION:
¼ Be careful not to scratch housing or input
shaft during dust cover removal. Also do not
allow foreign matter to enter housing interior.
¼ Replace dust cover with a new one if its
inside bore or lips are worn or damaged.
(1)
Dust cover
12) Remove the two bolts securing valve housing.
(1)
Socket bolt
S4M0394A
S4M0409A
S4M0410A