Subaru 2001 FORESTER Service Manual page 70

11) Apply a coat of grease to inner wall of valve
housing, oil seal and outer perimeter of dust seal.
(1) Valve housing
12) Using ST and press, install oil seal in valve
housing.
(1) Face oil seal in the direction shown in figure
when installing.
(2) To avoid scratching oil seal, apply a coat of
grease to contact surface of installer and oil
seal.
(3) To facilitate installation, attach oil seal to
installer and position in valve housing before
pressing into place.
ST 34099FA000 INSTALLER & REMOVER
(1) Oil seal
STEERING GEARBOX [RHD MODEL]
S4M0413A
H4M1251B
PS-69
Power Assisted System (Power Steering)
13) Attach ST2 to ST1, and press ball bearing into
place using a press.
NOTE:
¼ To facilitate installation, attach ball bearing to
remover and position in valve housing before
pressing it into place.
¼ Use the "B" end of remover.
ST1 34099FA000 INSTALLER & REMOVER
ST2 34099FA050 SPACER
(1) B side
14) Charge oil seal with specified steering grease.
15) Apply a coat of specified steering grease to ST
surface, and install ST onto end of input shaft.
Insert pinion and valve until "A" of oil seal contacts
"B" of valve housing. The ST is used to prevent
scratching oil seal.
ST 34099FA020 GUIDE
S4M0414A
G4M0840
G4M0841