Subaru 2001 FORESTER Service Manual page 40

8) Remove snap ring using snap ring pliers.
CAUTION:
¼ Do not reuse removed snap ring.
¼ Be careful not to scratch pinion and valve
assembly.
9) Press out bearing together with backing washer
using pipe of I.D. 38.5 to 39.5 mm (1.516 to 1.555
in) and press.
CAUTION:
Do not reuse removed bearing.
(1) Bearing
(2) Backing washer
(3) Oil seal
(4) Pipe
10) Remove oil seal.
CAUTION:
Do not reuse removed oil seal.
STEERING GEARBOX [LHD MODEL]
G4M0147
S4M0403A
PS-39
Power Assisted System (Power Steering)
D: ASSEMBLY
S601272A02
1. RACK HOUSING ASSEMBLY
CAUTION:
Use only SUBARU genuine grease for gearbox.
Grease:
VALIANT GREASE M2
[Part No. 003608001, net 0.5 kg (1.1 lb)]
1) Clean all parts and tools before reassembling.
2) Apply grease to teeth of rack so that grease
applied is about as high as teeth, and also apply a
thin film of grease to sliding portion of rack shaft.
CAUTION:
¼ When moving rack to stroke end without tie-
rod attached, prevent shocks from being
applied at the end.
¼ Do not apply grease to threaded portion at
end of rack shaft.
¼ Move rack shaft to stroke end two (2) or three
(3) times to squeeze grease which accumulates
on both ends. Remove grease to prevent it
from choking air passage hole.
3) Apply grease to sleeve insertion hole.
4) Apply grease to dust seal insertion hole.
CAUTION:
Apply clean grease with clean hands. If mate-
rial having a sharp edge is used for applying
grease, oil seal at the inside might be damaged.
5) Apply grease to sliding surface of sleeve and
spring seat, then insert sleeve into pinion housing.
Fit spring into sleeve screw, pack grease inside of
screw, then install the screw.
(1) Adjusting screw
(2) Spring
(3) Sleeve
6) Force-fit oil seal using ST.
ST 34099FA110 INSTALLER
CAUTION:
Be careful not to damage or scratch cylinder
inner wall.
NOTE:
¼ Apply specified power steering fluid to oil seal.
S601272A0201
B4M1129B