Subaru 2001 FORESTER Service Manual page 96

B: INSTALLATION
1. NON-TURBO MODEL
1) Install bracket on engine.
Tightening torque:
22 N·m (2.2 kgf-m, 15.9 ft-lb)
2) Install oil pump on oil tank as follows outside
the vehicle:
NOTE:
Prior to installation, make sure that all oil is
removed from oil pump, oil tank and pipe.
3) Place oil pump in a vise and install stay to oil
pump.
CAUTION:
Do not place oil pump directly in vise; use soft
pads and hold oil pump lightly to protect it.
Tightening torque:
15.7 N·m (1.60 kgf-m, 11.6 ft-lb)
4) Install lower shell to oil pump.
Tightening torque:
18 N·m (1.8 kgf-m, 13.0 ft-lb)
CAUTION:
Be sure to use a new seal washer.
(1) Lower shell
5) Install upper shell and baffle to lower shell.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
OIL PUMP
S601070A11
S601070A1104
H4M1075B
PS-95
Power Assisted System (Power Steering)
(1) Upper shell
(2) Lower shell
6) Install oil pump, previously assembled to oil
tank, on bracket.
Tightening torque:
18 N·m (1.8kgf-m, 13.0 ft-lb)
(1) Oil pump
7) Install in the reverse order of removal.
8) Inspect pulley belt
ME(SOHC)-43, INSPECTION, V-belt.>
9) Feed the specified power steering fluid. <Ref. to
PS-101, Power Steering Fluid.>
2. TURBO MODEL
1) Install oil pump to bracket.
(1) Place oil pump bracket in a vise. Tighten
bushing using a 12.7 mm (1/2") type 14- and
21-mm box wrench until it is in contact with oil
pump mounting surface.
CAUTION:
Do not place oil pump bracket directly in the
vise; use soft pads and hold oil pump lightly to
protect the pump.
H4M1078B
H4M1077B
tension. <Ref.
S601070A1105
to