Subaru 2001 FORESTER Service Manual page 61

Power Assisted System (Power Steering)
8) Slide dust cover out.
CAUTION:
¼ Be careful not to scratch housing or input
shaft during dust cover removal. Also do not
allow foreign matter to enter housing interior.
¼ Replace dust cover with a new one if its
inside bore or lips are worn or damaged.
(1) Dust cover
9) Remove the two bolts securing valve housing.
(1) Socket bolt
10) Remove valve housing, pinion and valve as a
unit.
STEERING GEARBOX [RHD MODEL]
S4M0409A
S4M0410A
G4M0819
PS-60
11) After removing dust cover, extract pinion and
valve from valve housing.
CAUTION:
¼ If pinion and valve is difficult to remove, use
a press.
¼ Discard oil seal after removal and replace
with a new one.
¼ Check rotor for bends and serrations for
damage and replace as required.
12) Using ST and press, remove dust seal,
back-up washer, oil seal and ball bearing from
valve housing.
CAUTION:
¼ Use the "A" end of remover.
¼ Do not apply a force to end surface of valve
housing.
¼ Do not reuse oil seal after removal.
ST 34099FA000 INSTALLER & REMOVER
(1) Oil seal
(2) Ball bearing
(3) A side
(4) B side
G4M0824
H4M1250B