Subaru 2001 FORESTER Service Manual page 45

Power Assisted System (Power Steering)
26) Inspect gearbox as follows:
"A" Holding tie-rod end, repeat lock to lock two or
three times as quickly as possible.
"B" Holding tie-rod end, turn it slowly at a radius
one or two times as large as possible.
After all, make sure that boot is installed in the
specified position without deflation.
27) Remove gearbox from ST.
ST 926200000 STAND
28) Install four pipes on gearbox.
(1) Connect pipes A and B to four pipe joints of
gearbox. Connect upper pipe B first, and lower
pipe A.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(2) Connect pipes C and D to gearbox.
Connect lower pipe C first, and upper pipe D
second.
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
2. CONTROL VALVE ASSEMBLY
Specified steering grease:
VALIANT GREASE M2 (Part No.
003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to
inner wall of valve housing.
(1) Fluid
3) Attach ST2 to ST1, and press oil seal into place
using a press.
STEERING GEARBOX [LHD MODEL]
G4M0127
S601272A0202
S4M0162B
PS-44
ST1 34099FA120 SEAL INSTALLER &
REMOVER
ST2 34099FA130 SEAL INSTALLER
(1) Face oil seal in the direction shown in figure
when installing.
(2) To avoid scratching oil seal, apply a coat of
grease to contact surface of installer and oil
seal.
(3) To facilitate installation, attach oil seal to
installer and position in valve housing before
pressing into place.
4) Using ST and press, install special bearing in
valve housing.
ST 34099FA120 SEAL INSTALLER &
REMOVER
NOTE:
To facilitate installation, attach ball bearing to
remover and position in valve housing before
pressing it into place.
(1) Special bearing
(2) Oil seal
S4M0160A
S4M0161B