Subaru 2001 FORESTER Service Manual page 56

2) Secure gearbox removed from vehicle in vise
using ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox assembly in a vise using
the ST as shown. Do not attempt to secure it
without this ST.
(1) Clamp
3) Pry off clip from outer end of boot, and slide
boot toward tie-rod end.
(1) Clip
4) Using ST, remove lock wire from inner end of
boot, and remove boot.
ST 927590000 WRENCH
(1) Wire
STEERING GEARBOX [RHD MODEL]
S4M0388A
S4M0389A
S4M0390A
PS-55
Power Assisted System (Power Steering)
5) Extend rack approximately 40 mm (1.57 in) out.
Unlock lock wire at lock washer on each side of
tie-rod end using a standard screwdriver.
CAUTION:
Be careful not to scratch rack surface as oil
leaks may result.
NOTE:
Parts requiring replacement are described in the
smallest unit of spare parts including damaged
parts and spare parts damaged. In actual disas-
sembly work, accidental damage as well as inevi-
table damage to some related parts must be taken
into account, and spare parts for them must also
be prepared. However, it is essential to pinpoint the
cause of trouble, and limit the number of replace-
ment parts as much as possible.
6) Using ST, loosen lock nut.
ST 926230000 SPANNER
(1) Lock nut
G4M0791
S4M0391A