Subaru 2001 FORESTER Service Manual page 68

28) Attach lock wire to boot large end, and twist it
while pulling it upward (with a force of approxi-
mately 39 N (4 kgf, 9 lb).
ST 927590000 WRENCH
CAUTION:
Ensure that lock wire is not loose.
(1) Wire
29) Then bend wire end along boot as shown.
(1) Twist wire up to this point.
30) Install clip using pliers.
CAUTION:
After installing clip, ensure that boot's small
end is properly positioned in groove on tie-rod.
(1) Clip
STEERING GEARBOX [RHD MODEL]
S4M0390A
S4M0400A
S4M0401A
PS-67
Power Assisted System (Power Steering)
31) Install pipes A and B.
Tightening torque:
Valve housing side
20 N·m (2.0 kgf-m, 14.5 ft-lb)
Steering body side
24 N·m (2.4 kgf-m, 17.4 ft-lb)
2. CONTROL VALVE ASSEMBLY
1) Clean all parts and tools before reassembling.
2) Attach ST to pinion, and apply grease to outer
perimeter of the cover and mating surface of oil
seal.
ST 926270000 COVER
3) Apply a coat of grease to spacer and sealing
lips of oil seal, and install spacer and oil seal.
CAUTION:
¼ Face chamfered side of spacer toward oil
seal.
¼ Face oil seal in correct direction.
(1) Spacer
(2) Oil seal
S601276A0202
G4M0828
S4M0419A