Subaru 2001 FORESTER Service Manual page 66

with two bolts to 25 N·m (2.5 kgf-m, 18.1 ft-lb).
Then, measure clearance between steering body
and valve housing using a thickness gauge.
Remove shims so that the clearance is zero.
20) Extend rack 72.4 mm (2.850 in) beyond pinion
side of steering body.
(1) Rack
21) Apply grease to pinion gear teeth and ball
bearing. Insert valve into place.
22) Alternately and slowly tighten socket bolts.
NOTE:
Replace faulty parts before installing valve.
Otherwise, valve may not be installed properly.
Tightening torque:
25 N·m (2.5 kgf-m, 18.1 ft-lb)
STEERING GEARBOX [RHD MODEL]
S4M0436A
G4M0853
PS-65
Power Assisted System (Power Steering)
23) Apply a coat of grease to sliding surface of
seat pad, sleeve and seating surface of spring, and
insert sleeve into steering body. Charge adjusting
screw with grease, insert spring into adjusting
screw and install on steering body.
(1) Seat pad
(2) Sleeve
(3) Spring
(4) Adjusting screw
(5) Lock nut
24) Installation of tie-rod
(1) Tighten adjusting screw until it will no longer
tighten.
(2) Install lock washers and tighten left and
right tie-rods into rack ends.
On condition
L: Approximately 40 mm (1.57 in)
Tightening torque:
78 N·m (8.0 kgf-m, 58 ft-lb)
S4M0274A
G4M0804