Subaru 2001 FORESTER Service Manual page 60

(1) Sharp-edged, long rod
(2) Seal ring
(3) O-ring
2. CONTROL VALVE ASSEMBLY
1) Disconnect four pipes from gearbox.
2) Secure gearbox removed from vehicle in vice
using ST.
ST 926200000 STAND
CAUTION:
Secure the gearbox assembly in a vice using
the ST as shown. Do not attempt to secure it
without this ST.
(1) Clamp
3) Pry off clip from outer end of boot, and slide
boot toward tie-rod end.
(1) Clip
STEERING GEARBOX [RHD MODEL]
S4M0423A
S601276A0602
S4M0388A
S4M0389A
PS-59
Power Assisted System (Power Steering)
4) Using ST, remove lock wire from inner end of
boot, and remove boot.
ST 927590000 WRENCH
(1) Wire
5) Using ST, loosen lock nut.
ST 926230000 SPANNER
(1) Lock nut
6) Tighten adjusting screw until it no longer tight-
ens.
(1) Adjusting screw
7) Loosen adjusting screw and remove spring and
sleeve.
CAUTION:
Replace spring and/or sleeve if damaged.
S4M0390A
S4M0391A
S4M0392A