Subaru 2001 FORESTER Service Manual page 64

9) Install ST on rack and equally apply a thin coat
of grease to rack and ST, then install oil seal.
ST 926250000 GUIDE
CAUTION:
Be careful not to scratch oil seal lips with pis-
ton's knurl section.
(1) Rack piston inner ring
(2) Outer side oil seal
(3) Rack
10) Apply a coat of grease to grooves in rack,
sliding surface of sleeve and sealing surface of
piston. Install ST on the end of steering body cyl-
inder. Then insert rack into steering body from cyl-
inder side.
ST 34099FA010 GUIDE (Oil seal)
CAUTION:
¼ Be sure to apply grease so that it covers the
entire surface of rack gear teeth.
¼ Do not allow grease to block air vent hole on
rack.
(1) Cylinder side of steering body
(2) Air vent hole
(3) Oil seal
(4) Rack
STEERING GEARBOX [RHD MODEL]
S4M0429A
S4M0430A
PS-63
Power Assisted System (Power Steering)
11) Slowly press inner side oil seal until distance
between ST and end of rack is 65 mm (2.56 in).
ST 34099FA010 GUIDE (Oil seal)
CAUTION:
Ensure ST's inner wall is free of scratches.
Otherwise, it may damage oil seal during instal-
lation.
(1) Rack piston
(2) Inner side oil seal
(3) Back-up ring
12) Pass ST2 and pipe through rack and press
outer side oil seal until ST1 is in contact with ST2.
ST1 34099FA010 GUIDE (Oil seal)
ST2 34099FA040 INSTALLER (Oil seal)
(1) Pipe
(2) Outer side oil seal
S4M0431A
S4M0432A