Subaru 2001 FORESTER Service Manual page 62

13) Remove snap ring securing valve sleeve to
pinion and valve, and remove valve sleeve.
CAUTION:
Be careful not to scratch pinion and valve when
removing snap ring.
(1) Valve sleeve
(2) Retaining ring
14) Remove oil seal and spacer.
15) Using a long rod, remove seal ring and O-ring
from pinion.
CAUTION:
Be careful not to scratch outer surface and seal
ring groove of input shaft. If scratched, sealing
effect will be lost, resulting in a malfunctioning
valve.
(1) Ball bearing
(2) Spacer
(3) Oil seal
(4) Seal ring
(5) O-ring
STEERING GEARBOX [RHD MODEL]
S4M0417A
S4M0418A
PS-61
Power Assisted System (Power Steering)
D: ASSEMBLY
S601276A02
CAUTION:
Use only SUBARU genuine grease for gearbox.
Specified grease for gearbox:
VALIANT GREASE M2 (Part No.
003608001)
1. RACK HOUSING ASSEMBLY
1) Clean all parts and tools before reassembling.
2) Move rack shaft fully to the left and right two or
three times to lubricate shaft ends with grease.
Remove excess grease, being careful not to block
air vent hole.
CAUTION:
¼ When rack is fully moved to its stroke ends
with tie-rod removed, be careful not to bump
rack ends.
¼ Ensure that screw located at end of rack
shaft is free from grease.
3) Apply grease to bore wall which accommodates
sleeve.
CAUTION:
Ensure that hands are clean when applying
grease.
4) Install O-ring and seal ring in groove on rack
piston.
CAUTION:
¼ Do not expand O-ring and seal ring more
than necessary.
¼ To facilitate installation of seal ring, first
position one half of entire seal ring in groove.
Then slowly position the second half using a
spatula, as shown.
(1) O-ring
(2) Seal ring
(3) Spatula
S601276A0201
S4M0424A