Subaru 2001 FORESTER Service Manual page 84

2) Temporarily connect pipes C and D. (LHD
model)
(1) Return hose
(2) Pressure hose
(3) Approx. 30 mm (1.18 in)
(4) Clamp E
(5) Pipe C
(6) Pipe
(7) Pipe (on gearbox side)
3) Using ST, remove flare nuts from control valve
of gearbox assembly, and disconnect upper and
lower hoses.
ST 34099AC050 GEARBOX SPANNER
CAUTION:
¼ Always disconnect hoses B and A in that
order.
¼ Be careful not to damage the hoses during
removal.
(1) Steering gearbox
PIPE ASSEMBLY
4) Temporarily install clamp E on pipes C and D,
and tighten clamp E firmly.
CAUTION:
Ensure that the letter "8" on each clamp are
diagonally opposite each other as shown in fig-
ure.
Tightening torque:
7.4 N·m (0.75 kgf-m, 5.4 ft-lb)
(1)
(2)
5) Tighten joint nut.
S4M0438A
Tightening torque:
15 N·m (1.5 kgf-m, 10.8 ft-lb)
6) Connect pipe A and B.
(1) LHD model
Connect pipes A and B to four pipe joints of gear-
box. Connect upper pipe B first, and lower pipe A
second.
Tightening torque:
13 N·m (1.3 kgf-m, 9.4 ft-lb)
(1)
(2)
S4M0235B
PS-83
Power Assisted System (Power Steering)
Clamp E
Pipe C
Pipe A
Pipe B
B4M0667C
S4M0381A