Choosing Dynacolor Sets - Barco Galaxy NW-12 User Manual

7. Advanced
Image 7-161
7.9.7.2

Choosing DynaColor sets

Choosing DynaColor set can be done by the operator.
Overview of Dynacolor sets
Depending on the projector settings, different Dynacolor sets are enabled and/or available:
• Monoscopic mode: two Dynacolor sets (Set 1 and Set 2) can be selected and adjusted;
• Active stereo mode: two Dynacolor sets (Set 1 and Set 2) can be selected and adjusted;
• Active Infitec stereo mode: two Dynacolor sets (Infitec A and Infitec B) can be adjusted. Set A is used for the left-eye images,
while Set B is used for the right-eye images. These sets are automatically selected when the Infitec filter moves into the projector
light path;
• Passive Infitec stereo mode: one Dynacolor set (Infitec A or Infitec B, depending on the Infitec filter in the projector) can
be adjusted. This set is automatically selected when the Infitec filter moves into the projector light path.
In the following procedures we will only explain the selection of Set 1. The same procedure applies for Set 2.
142 R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013